en:start:3_gt6:rahmen
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
en:start:3_gt6:rahmen [22:57 26 /12/2023] – gelöscht - Externe Bearbeitung (Unbekanntes Datum) 127.0.0.1 | en:start:3_gt6:rahmen [22:57 26 /12/2023] (current) – ↷ Seite von en:start:6_gt6:rahmen nach en:start:3_gt6:rahmen verschoben peter | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Frame ====== | ||
+ | {{ start: | ||
+ | |||
+ | Without major rust defects (only flash rust), only the tips of the front outriggers are damaged by the poorly attached bodywork and need to be repaired... | ||
+ | |||
+ | Speaking of shitty bodywork: | ||
+ | Since the screw points of the thrust struts in the body were only glued in with silicone, another strut was welded to the frame...not that anything else gets lost: | ||
+ | |||
+ | At some point, a retaining plate for the stabilizer bar was lost....And the stabilizer bar with it: | ||
+ | Happens when someone takes the lashing eyes, with which the car was shipped to the USA at the time, for towing.... | ||
+ | {{ start: | ||
+ | |||
+ | \\ | ||
+ | |||
+ | So frame completely stripped of paint, primed with BranthoKorrux 3in1...and of course repaired: | ||
+ | {{start: | ||
+ | |||
+ | {{ start: |